600W single output PFC AC/DC switching power supply
Ø Universal AC input/ Full range
Ø Built-in active PFC function,PF>0.96
Ø Using ZVS technology to reduce power dissipation
Ø Built in Fan speed control and over temp.protection
Ø Built in AC inrush current limiting circuit(<20A)
Ø Build in constant current limiting circuit
Ø Built in Remote Sense Function
Ø Build in DC OK signal
Ø Wide operating ambient temperature (-20℃~70℃)
Ø 1 U low profile,42.5mm
Ø 3 years warranty
|
MODEL |
PDF-600-12
PDF-320-5 |
PDF-600-24
PDF-320-12 |
PDF-600-36
PDF-320-32 |
PDF-600-48
PDF-320-48 |
|
OUTPUT |
DC Output |
12V
5.0V |
24V
12V |
36V
32V |
48V
48V |
|
Rated Current |
50A
60A |
25A
25A |
17.5A
10A |
12.25A
6.7A |
|
Current Range Note 1 |
0~50A
0~60A |
0~25A
0~25A |
0~17.5A
0~10A |
0~12.25A
0~6.7A |
|
Ripple and Noise
Note 2 |
0-70℃ |
120mV
150mV |
150mV
150mV |
150mV
200mV |
200mV
240mV |
|
-30℃ |
180mV
180mV |
150mV
150mV |
150mV
200mV |
200mV
240mV |
|
Voltage ADJ. Range |
±10% of rated output voltage |
|
Voltage Accuracy |
±2.0%
±2.0% |
±2.0%
±1.0% |
±2.0%
±1.0% |
±2.0%
±1.0% |
|
Line Regulation |
±0.5%
±0.5% |
±0.5%
±0.3% |
±0.5%
±0.2% |
±0.2%
±0.2% |
|
Load Regulation |
±1.0%
±1.0% |
±1.0%
±0.5% |
±1.0%
±0.5% |
±1.0%
±0.5% |
|
Set-up Time |
＜1.5S (230Vac input, Full load), ＜3S (115Vac input, Full load) |
|
Hold up Time |
＞16mS/ (230Vac input, Full load) |
|
Temperature Coefficient |
±0.05%/℃ |
|
Overshoot and Undershoot |
<5.0% |
|
INPUT |
Voltage Range |
90Vac~264Vac,127Vdc~370Vdc |
|
Frequency Range |
47Hz--63Hz |
|
Power Factor(Typical) |
PF＞0.98/115VAC PF＞0.96/230VAC |
|
Efficiency ( Typical) |
88%
79% |
89%
86% |
90%
87% |
90%
88% |
|
AC Current (max.) |
<7A |
|
Inrush Current (Typical) |
<20A@230Vac Cold start |
|
Leakage Current |
Input—output: ≤0.1mA Input—PG: ≤0.75mA |
|
PROTECTION |
Over Load |
110%~135% of rated output current, constant current |
|
Over Temperture |
105℃+5℃(detect on Mosfet temperature);shut down,auto recovery after the temperature goes down to 75℃ |
|
Over Voltage |
110%~150% of rated voltage; constant voltage |
|
Short Circuit |
Long-term mode, constant current, auto recovery |
|
ENVIRONMENT |
Operating amb. Temp. & Hum. |
-30℃~70℃; 20%~90%RH No condensing (refer to derating curve) |
|
Storage Temp. & Hum. |
-40℃~85℃; 10%~95%RH No condensing |
|
SAFETY &EMC
(Note 3) |
Safety Standards |
IEC60950/ UL60950 /; EN60950-1：2006 |
|
Withstand Voltage |
Primary-Secondary:3.0KVac; ≤10mA .Primary-PG:1.5KVac; ≤10mA. Secondary-PG:0.5KVac;≤10mA. |
|
Isolation Resistance |
≥100M ohms |
|
EMI Conduction&Radiation |
Compliance to EN55022(CISPR22)ClassB |
|
Harmonic Current |
Compliance to EN61000-3-2,17625.1-2003 |
|
EMS Immunity |
Compliance to EN61000-4-2,3,4,5,6,8,11;ENV50204,light industry level,criteriaA |
|
OTHERS |
MTBF (MIL-HDBK-217F) |
More than 200,000Hrs (25℃, Full load) |
|
Dimension (L*W*H) |
218×116.5×42.5mm |
|
Packing |
6PCS/CTN, 8.7KGS, 0.04CBM |
|
Cooling method |
Fored air cooling(Built-in fan) |
|
NOTE |
- All parameters NOT specially mentioned are measured at rated input, rated load and 25℃ of ambient temperature.
- Measured at 20MHz of bandwidth by using a 12” twisted pair-wire terminated with a 0.1 uF & 47uF parallel capacitor.
3. The SPS is considered a component which will be installed into final equipment. The equipment must be re-confirmed that it still meets EMC directives |
|
